The design features of the whole product of the heat preservation and decoration board

At present, the application of energy-saving materials for thermal insulation integrated boards has become the mainstream of buildings. In many ways, it determines the service life and actual effects of buildings.

insulation decoration integrated board

Combined with the practical application of thermal insulation and decoration board, the characteristics of the whole product are mainly concentrated in the following aspects:

one is the diversity of functions.

Second, the mass production quality of thermal insulation and decoration integrated board is stable, the production level is high, and it is not affected by the construction environment.

Third, the decoration effect of the integrated board with other thermal insulation decoration is ideal, and it is green and environmentally friendly, and has a longer service life.

Insulation and decoration integrated board is divided into base layer, insulation layer and decoration layer. When designing and producing board manufacturers, they should comply with relevant national regulations, as follows:

1. The thickness of the insulation layer is generally greater than 2cm, and the inner surface temperature is higher than 0 degrees.

2. Waterproof design, thermal insulation decoration integration board is qualified the basic standard, otherwise, after water seepage insulation layer is invalid.

3. If the height of the building is higher than 50 meters, the density of the fluorocarbon paint panel should be less than 10 kilograms per square meter.

4. The bonding area between the decorative board and the base board is not less than 40%. If the bonding area of the building is greater than 50 meters, the bonding area between the boards is not less than 60%.

5. The number and fixing depth of mechanical fixing parts of each thermal insulation and decoration integrated board have corresponding standards. Generally, the depth should not be less than 25mm and the number should not be less than 3.

6. The filling width and filling depth of the foam filler at the deformation joint should meet the corresponding standard requirements, generally not less than 3 times the seam width.